If you are in the process of sprucing up your home with a brand new coat of paint, then you need to review this. Apart from the fact that you need to select your paints carefully so that you get the right shade and tone, you would also need a gib stopper, to give you that flawless finish. The better thing to do here would be to hire a professional to handle it but you must understand the basics of plastering and painting so that you can choose the right person. Here’s more info on a quality finish and what you need to aim for,
- Interiors: It does not matter if you are planning to get your interiors painted by a top-notch painter. As the paint dries up, you would be bound to notice cracks and even blemishes appearing through the new coat. And that’s essentially why you use gib stoppers in Auckland. Just check in with the painter and inform him that you would want him to use plasterboards before any painting is done. These boards can be affixed directly to the frames, which in turn can support them. And with a fresh coat of plaster, the paint can then be applied over with the result, a quality finish. That’s why you need to be careful who you call over to do your interiors.
- Get the framing right: When it comes to plasterboards, it is essential that the frames are dry and fixed accurately. Otherwise, it will not matter how effective the plasterer is, the finish will not be perfect. And if the framing is not dry enough, it is going to warp as it dries and may even break off at certain points. All of these are reasons enough to check and verify that the framing was done properly and in the right way. Otherwise, it is going to end up causing cracks to appear in the paint, thereby marring the finish.
- Metal ceiling battens: You may want to talk to your contractor before he begins constructing your new home. Ask him to affix metal ceiling battens, as it does not get wet, nor does it shrink, twist or even break. So the plasterboards can be affixed safely to the ceilings without worrying about the finish and if it will impact the same.
- Select the right boards for the ceiling: As you discuss the project with your plasterer, you must point out the need for 13mm ceiling boards as opposed to anything smaller. And as the gib boards are affixed to the ceiling, the size of the boards should be rigid enough and not collapse from the effects of gravity or any structural flaws. After all, you would want the same finish for your ceilings as you do for your walls, right?
- Keep the joints to a minimum: When it comes to affixing the plasterboards, you may want to keep the joints to a minimum. You need to do this since any imperfection or flaw is bound to show up, right along where the joints are placed.
These are some of the fundamentals that you need to implement as you affix the boards.
